Tricity-bendix SIE524 Manuale Utente Pagina 8
- Pagina / 32
- Indice
- SEGNALIBRI
Valutato. / 5. Basato su recensioni clienti
8
WARNING: THIS APPLIANCE MUST BE EARTHED
RATING PLATE
This is situated on the front frame of the appliance
and can be seen upon opening the top cavity door.
Alternatively the rating plate may also be found on
the back or top of some models (where applicable).
The appliance must be protected by a suitably
rated fuse or circuit breaker. The rating of the
appliance is given on the rating plate.
Do not remove the rating plate from the
appliance as this may invalidate the guarantee.
INSTALLATION
If your appliance has been damaged in transit,
contact your supplier immediately. DO NOT
attempt to install it.
Your appliance left the factory fully packaged to
protect it from damage. If it is delivered without
packaging and damage has occurred, the
manufacturer cannot accept responsibility. Contact
your supplier for advice.
Once the packaging has been removed the
appliance should only be moved by hand. DO
NOT use a sack barrow or any other aid to lift the
appliance as damage may occur.
Connection to the electricity supply must be carried
out by a qualified electrician/competent person.
The recommended cross-section area is six square
millimetres (6.00mm
2
).
The electrical connection should be made using a
double pole isolating switch (cooker socket) with at
least 3mm contact separation in all poles. The
cable must have conductors of sufficiently high
cross-sectional area to prevent overheating and
deterioration.
The cable must be routed away from potentially hot
areas marked by X in the diagram below.
To move the appliance, open the fan oven door,
and lift the appliance by holding inside the top of
the compartment.
This is a type Y appliance which means it is free-
standing and can be fitted with cabinets on one or
both sides. It may also be fitted in a corner setting.
Ensure that the appliance is standing level.
Side walls which are above hob level should be
protected by heat resistant non-combustible
material and MUST NOT be nearer than 40mm to
the hob side.
A nominal air gap of 2mm all around the appliance
is required to enable the appliance to be moved
into position.
Always ensure an air gap is maintained at hotplate
level. Tiles or other forms of deep wall covering
should not obscure this gap.
INTRODUCTION
REAR VIEW
Air gap
- SLIP IN ELECTRIC COOKER 1
- MODEL NO. SIE 524 2
- TECHNICAL DETAILS 2
- CONTENTS 3
- AFTER USE 7
- INTRODUCTION 8
- GRILL AND OVEN FURNITURE 10
- THE CONTROL PANEL 11
- FEATURES 11
- + ) Increase control 12
- 2) THE MINUTE MINDER 13
- USING THE HOB 14
- RECOMMENDED SAUCEPANS 14
- HINTS AND TIPS 14
- DEEP FAT FRYING 15
- PRESERVING 15
- GRILLING CHART 17
- THE TOP OVEN 18
- THE MAIN FAN OVEN 20
- OVEN COOKING CHART 22
- ROASTING CHART 23
- USES OF DEFROST FEATURE 24
- SELECTING DEFROST 24
- THINGS TO NOTE 24
- CARE AND CLEANING 25
- TO CLEAN THE INNER GLASS DOOR 28
- REPLACING THE OVEN LIGHT BULB 28
- SOMETHING NOT WORKING? 29
- SERVICE AND SPARE PARTS 30
- CUSTOMER CARE DEPARTMENT 30
- Standard guarantee conditions 31
- Exclusions 31
- European Guarantee 31
Prodotti e manuali riguardandi Piani cottura Tricity-bendix SIE524
(36 pagine)Flex TPO 60 Self Adhered manuali
Manuali dei proprietari e guide per l'utente per Per casa Flex TPO 60 Self Adhered.
We fornisce 1 manuali pdf Flex TPO 60 Self Adhered per scaricare gratuitamente in base al tipo di documento: Manuale Utente
Commenti su questo manuale